I don t want a new fan i just want some permanent way to cover the hole preferably without lifting shin gles and felt to avoid creating any leaks.
Attic fan cover blew off.
Use a ladder to access the vent and tighten the screws of the vent cover with a screwdriver.
The cause of the problem could be the belt.
Most of these fan units are built with the shroud housing cover made as a part of the entire unit.
Another thing to remember is to cover the large attic exhaust vent in the off season.
Unfortunately due to being sick i m not supposed to drive and since it was going to rain i just used a tarp and some duct tape today to seal it off so the rain doesn t get in tonight.
This 48 x48 attic fan cover is very easy to install.
Last year i tried a round plastic toy sled same size as the old fan cover.
Generally speaking if the cover blows off the entire unit would need to be replaced.
This would be the job of a roofing contractor although an electrician may be necessary to wire the fan back into the circuit.
With fan off go into the attic.
Because most vent covers are.
Spray some lubricant wd 40 or similar into the air ports at the top bottom of the air holes in the fan housing for about 3 to 5 seconds.
Worked pretty well and was an obvious choice before the family had central ac.
Whole house attic fan grew up with one in the 60s in ny.
Tap the motor a few times with the handle end of a hammer or piece of wood as if you were swatting a bug.
An attic fan can create enough draft to blow out a pilot light on a furnace.
If this happens the furnace will empty gas out into the attic.
You don t have to go into the attic before you install it and it can be easily removed when the time comes.
Securing vents loose vent covers can allow rain to blow into the attic.
I m not sure what happened but the cap top of the attic fan on my roof blew off sometime over the winter and my neighbor was kind enough to let me know.
Covered by the attic fan cover before that cover blew off last year the f an itself broke and was removed years ago.
You ll need to take out the outer casing of the fan and look to see if the belt is cracked sagging worn out or broken.