Although the sheet metal face feature may be considered the most fundamental of sheet metal features sheet metal parts consisting of a single face are in the minority.
Autodesk inventor sheet metal flange.
I added a flange a couple actually to a part and two of them did not center properly.
Create a contour flange.
You can override the default sheet metal.
Upon measuring the slots are correct to the flange but the flange is not centered on the sheet.
You can also specify the width or offset of the new flange.
Use the flange command to add a sheet metal face and a bend to an existing sheet metal face.
Set a distance for the height of the flange or select to and select geometry to define.
Learn more about the flange feature in this vi.
The flange previews along the edge selected using the default parameters.
Create sheet metal flange along edge on the ribbon click sheet metal tab create panel flange.
The sheet metal flange feature consists of a face and bend connected to an existing face along a straight age.
Now that i have all you need is a parameter that is the distance from the plane to the edge of the face where the flange starts then use this plus the 12 in cos 45 deg.
I am using inventor 2019.
Project sheet metal flange to plane at that point i hadn t seen the image you posted so i didn t know where the reference plane was in relation to the flange.
Flange features are added by selecting one or more edges and specifying a set of options that determine the size and.
To add a flange feature you select one or more edge and specify a set of options that determine the size and position of the material added.
A flange feature consists of a face and bend connected to an existing face along a straight edge.
Corners that generate during the creation of flange and contour flange features display the default corner relief shape when the model is flat.
If there are two or more solid bodies in the part file click the solids selector to choose the participating solid body.
Notice in the first photo that the slotted hole is off center.
You can specify the depth and the angle of the flange and whether it is created inside or outside the existing face.
To add a flange feature you select one or more edges and specify the size and position of the material added.
Click an open profile.
Create a 2d open profile sketch.
You can override the default sheet metal style settings using the unfold options and the bend or corner tabs on the feature creation dialog box.
I did not realize it until i used the part in an assembly.
A flange feature consists of a face and bend connected to an existing face along a straight edge.
On the ribbon click sheet metal tab create panel contour flange.
Create a flange and define its width as an offset.
The edge select mode is active.
