Use a d pin or something fancier to set the height.
Awning out of pvc.
Awnings are typically made with a metal frame and are composed of some type of fabric.
Drill one hole about an inch down from the top of the larger pipe.
I did not glue this piece.
A window awning is installed directly above a window on the exterior of a house.
Choose a length of pvc and elbow so that the awning hangs at a desired angle.
Place the patio awning material on a flat clean surface and fold about a 1 5 8 inch piece over to the wrong side.
Pin it 5 8 inch from the end for a couple inches along the length and then take a piece of your pvc pipe and test the fit.
Use a pvc pipe that the frame pipe will fit into.
I wanted to be able to still see out of the window so if you do too test the angle with someone inside.
I picked the about 45 degrees.
The outer pipe has one hole and the inner pipe attached to the awning has multiple holes.
You can make a window awning with pvc pipe.
If it s too snug fold a little more fabric over.
Https youtu be kz0amsvu5uq message me to send you full write up.
Heavy duty brown 8x10 ft tarp i.
Fch window awning door canopy 40 x 40 window awning overhead door modern polycarbonate cover outdoor front door patio canopy uv rain snow sunlight protection hollow sheet silver gray by fch 36 99 36.